TP-Link JetStream Series Quick Start Manual

Installation Guide
JetStream Gigabit Smart PoE+ Switch
Connection
3
AC Power Cord
2
DC Power Adapter
Note:
1. PoE ports can also connect to non-PoE devices, but only transmit data.
2. Maximum PoE power is 30 W for each PoE port and 58 W for all PoE ports.
Configuration
1. To access the GUI of the switch, open a browser and type the default
management address http://192.168.0.1 in the address field of the
browser, then press the Enter key.
Note:
To log in to the switch, the IP address
of your PC should be set in the same
subnet as that of the switch. The IP
address is 192.168.0.x ("x" is any
number from 2 to 254). Subnet Mask
is 255.255.255.0. For details, please
refer to Appendix B in the User Guide
on the resource CD.
1
PC
LED Explanation
PoE MAX
PoE MAX
On: 51 W≤Total power supply<58 W
Flashing: Total power supply keeps≥
51 W more than 2 minutes
Off: Total power supply<51 W
Power
Power
On: Power on
Off: Power off
SPF1/SFP2
SPF1 SPF2
On (Green): Connected to a 1000 Mbps
device
On (Yellow): Connected to a 100 Mbps
device
Flashing: Transmitting/receiving data
Ethernet Ports (1–8)
PoE Devices
IP Camera AP
2. Enter admin for both the username
and password in the lower case
letters. Then click the Log In button
or press the Enter key. (The first time
you log in, change the password to
better protect your network and
devices.)
3. After a successful login, the main
page will appear. You can click the
menus on the top side and left side
to configure the corresponding
functions.
Note:
For more details about how to configure the switch, see the Configuration
Guide on the resource CD.
Link/Act (port 1–8)
On (Green): Running at 1000 Mbps
On (Yellow): Running at 10/100 Mbps
Flashing: Transmitting/receiving data
System
Flashing: System running normally
On/Off: System running abnormally
PoE Status (port 1–8)
On: Providing PoE power
Flashing: Current-overload/Short-circuit/
Connected to a Non-standard PD/Power
exceeded the user-defined value
Off: Not providing PoE Power
SFP Slots
IP Phone
Link/Act
System
PoE Status