HP ZBook Fury 17 G7 Maintenance And Service Manual page 94

1. Prepare the computer for disassembly
2. Remove the service cover
1. Battery (see
2. Solid-state drives 3 and 4 (see
3. Solid-state drive carrier (see
4. Hard drive (see
5. Keyboard (see
6. Bottom case (see
Remove the fan/heat sink assembly:
1. Disconnect the fan cables (1) from the system board.
2. Release the webcam cable (2) and the wireless antenna cables from the retention clips (3) built into the
right fan.
3. Release the display panel cable from the retention clips (4) built into the left fan.
4. Remove the four Phillips M2.5 × 6.0 screws (5) that secure the the fan/heat sink assembly to the computer.
5. In the order indicated on the fan/heat sink assembly, loosen the eight captive Phillips screws (6) that
secure the the fan/heat sink assembly to the computer.
Computer models equipped with a graphics subsystem with UMA memory have only four captive screws
securing the fan/heat sink assembly to the computer.
6. Lift the front edge of the fan/heat sink assembly (7) until it rests at an angle.
80 Chapter 6 Removal and replacement procedures for authorized service provider parts
(Preparation for disassembly on page
(Service cover on page
Battery on page 41)
Solid-state drives 3 and 4 on page
Solid-state drives 3 and 4 on page
Hard drive on page 44)
Keyboard on page 54)
Bottom case on page
40), and then remove the following components:
42)
66)
66).
42)
ENWW