Fan/Heat Sink Assembly - HP ZBook Fury 17 G7 Maintenance And Service Manual

1. Release the ZIF connector (1) to which the card reader board cable is connected, and then disconnect the
card reader board cable from the system board.
2. Detach the card reader board cable (2) from the top cover. (The card reader board cable is attached to the
top cover with double-sided adhesive.)
3. Remove the four Phillips M2.0 × 2.9 broad head screws (3) that secure the card reader board to the top
cover.
4. Remove the card reader board (4) and cable.
Reverse this procedure to install the card reader board and cable.

Fan/heat sink assembly

To remove the fan/heat sink assembly, use these procedures and illustrations.
Table 6-7 Fan/heat sink assembly descriptions and part numbers
Description
All fan/heat sink assembly spare part kits include replacement thermal material.
For use on computer models equipped with AMD graphics cards
For use on computer models equipped with N19E graphics cards
For use on computer models equipped with N19P graphics cards
For use on computer models equipped with UMA graphics subsytems
Before removing the fan/heat sink assembly, follow these steps:
ENWW
Spare part number
M20098-001
M20097-001
M20096-001
M20095-001
Component replacement procedures 79