4.
Detach the NFC module (4) from the top cover. (The NFC module is attached to the top cover with double-
sided adhesive.)
Reverse this procedure to install the NFC module and cable.
Card reader board
To remove the card reader board, use this procedure and illustration.
Table 6-6
Card reader board description and part number
Description
Card reader board (includes cable)
Before removing the card reader board, follow these steps:
1.
Prepare the computer for disassembly
2.
Remove the service cover
1.
Battery (see
2.
Solid-state drives 3 and 4 (see
3.
Solid-state drive carrier (see
4.
Hard drive (see
5.
Keyboard (see
6.
Bottom case (see
Remove the card reader board:
78
Chapter 6 Removal and replacement procedures for authorized service provider parts
(Preparation for disassembly on page
(Service cover on page
Battery on page
41)
Solid-state drives 3 and 4 on page
Solid-state drives 3 and 4 on page
Hard drive on page
44)
Keyboard on page
54)
Bottom case on page
40), and then remove the following components:
42)
66)
Spare part number
M20106-001
66).
42)
ENWW