1.
Prepare the computer for disassembly
2.
Remove the service cover
1.
Battery (see
2.
Solid-state drives 3 and 4 (see
3.
Solid-state drive carrier (see
4.
Hard drive (see
5.
Keyboard (see
6.
Bottom case (see
Remove the touchpad:
1.
Detach the touchpad cable (1) from the top cover. (The touchpad cable is attached to the top cover with
double-sided adhesive.)
2.
Release the ZIF connector (2) to which the touchpad cable is connected, and then disconnect the touchpad
cable from the system board.
3.
Remove the four Phillips M2.0 × 2.9 screws (3) that secure the touchpad to the top cover.
4.
Remove the touchpad (4).
Reverse this procedure to install the touchpad.
NFC module cable
To remove the NFC module cable, use this procedure and illustration.
The NFC module cable is available in the Cable Kit, spare part number M20105-001.
ENWW
(Preparation for disassembly on page
(Service cover on page
Battery on page
41)
Solid-state drives 3 and 4 on page
Solid-state drives 3 and 4 on page
Hard drive on page
44)
Keyboard on page
54)
Bottom case on page
40), and then remove the following components:
42)
66)
Component replacement procedures
66).
42)
75