Fingerprint Reader Module - HP ZBook Fury 17 G7 Maintenance And Service Manual

3. Remove the fingerprint reader module cable (3).
Reverse this procedure to install the fingerprint reader module cable.

Fingerprint reader module

To remove the fingerprint reader module, use this procedure and illustration.
Table 6-3 Fingerprint reader module description and part number
Description
Fingerprint reader module
NOTE: The fingerprint reader module spare part kit does not include the fingerprint reader module cable.
The fingerprint reader module cable is available in the Cable Kit, spare part number M20105-001.
Before removing the fingerprint reader module, follow these steps:
1. Prepare the computer for disassembly
2. Remove the service cover
1. Battery (see
2. Solid-state drives 3 and 4 (see
3. Solid-state drive carrier (see
4. Hard drive (see
5. Keyboard (see
6. Bottom case (see
ENWW
(Preparation for disassembly on page
(Service cover on page
Battery on page 41)
Solid-state drives 3 and 4 on page
Solid-state drives 3 and 4 on page
Hard drive on page 44)
Keyboard on page 54)
Bottom case on page
40), and then remove the following components:
42)
66)
Component replacement procedures
Spare part number
M17064-001
66).
42)
71