Fingerprint Reader Module Cable - HP ZBook Fury 17 G7 Maintenance And Service Manual

5. Remove the SD card board (5) and cable
Reverse this procedure to install the SD card board and cable.

Fingerprint reader module cable

To remove the fingerprint reader module cable, use this procedure and illustration.
The fingerprint reader module cable is available in the Cable Kit, spare part number M20105-001.
Before removing the fingerprint reader module cable, follow these steps:
1. Prepare the computer for disassembly
2. Remove the service cover
1. Battery (see
2. Solid-state drives 3 and 4 (see
3. Solid-state drive carrier (see
4. Hard drive (see
5. Keyboard (see
6. Bottom case (see
Remove the fingerprint reader module cable:
1. Release the ZIF connector (1) to which the fingerprint reader module cable is connected, and then
disconnect the fingerprint reader module cable from the system board.
2. Release the ZIF connector (2) to which the fingerprint reader module cable is connected, and then
disconnect the fingerprint reader module cable from the fingerprint reader module.
70 Chapter 6 Removal and replacement procedures for authorized service provider parts
(Preparation for disassembly on page
(Service cover on page
Battery on page 41)
Solid-state drives 3 and 4 on page
Solid-state drives 3 and 4 on page
Hard drive on page 44)
Keyboard on page 54)
Bottom case on page
40), and then remove the following components:
42)
66)
66).
42)
ENWW