HP ZBook Fury 17 G7 Maintenance And Service Manual page 81

4. Remove the nine Phillips M2.5 × 6.0 (2) screws that secure the bottom case to the computer.
5. Remove the four Torx8 M2.5 × 3.5 (3) screws that secure the bottom case to the computer.
6. Insert a case utility tool (1) or similar thin plastic tool in the display hinge area and separate the bottom
case from the top cover.
7. Swing the rear edge of the bottom case (2) up and forward until it rests at an angle.
8. Remove the bottom case (3).
When removing the bottom case, take care not to damage the front edge (4) and the area around the
solid-state drive compartment. These areas of the bottom case have thin material and are susceptible to
breakage if precautions are not taken.
Reverse this procedure to install the bottom case.
ENWW Component replacement procedures 67