HP ZBook Fury 17 G7 Maintenance And Service Manual page 59

1. Loosen the three Phillips screws (1) that secure the hard drive to the computer.
2. Swing the carrier bar (2) up and to the left to release the hard drive.
3. Slide the hard drive (3) to the left, and then remove the hard drive from the computer.
Reverse this procedure to install the hard drive.
If you must disassemble the hard drive, follow these steps:
1. Remove the four Phillips M3.0 × 3.0 screws (1) that secure the hard drive cover to the hard drive.
2. Remove the cover (2) from the hard drive.
The hard drive cover is included in the Hard Drive Hardware Kit, spare part number M20091-001.
ENWW Component replacement procedures 45