Component Replacement Procedures; Preparation For Disassembly; Service Cover - HP ZBook Fury 17 G7 Maintenance And Service Manual

Component replacement procedures

To remove and replace computer components, use these procedures.
NOTE: Details about your computer, including model, serial number, product key, and length of warranty, are
on the service tag at the bottom of your computer.
NOTE: HP continually improves and changes product parts. For complete and current information about
supported parts for your computer, go to http://partsurfer.hp.com, select your country or region, and then follow
the on-screen instructions.
You must remove, replace, or loosen as many as 21 screws when you service Customer Self-Repair parts. Make
special note of each screw size and location during removal and replacement.

Preparation for disassembly

To prepare to disassemble the computer, use these steps.
See Removal and replacement procedures preliminary requirements on page 31
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the computer
on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.

Service cover

To remove the service cover, use this procedure and illustration.
Table 5-1 Service cover description and part number
Description
Service cover
Before removing the service cover, prepare the computer for disassembly
on page 66).
Remove the service cover:
1. Close the computer and rest it upside down on a flat work surface with the front toward you.
2. Slide the service cover release latch (1) to the right far enough to access the security screw.
3. If present, remove the Phillips M2.0 × 6.0 security screw (2) that secures the service cover release latch in
place.
4. Slide the service cover release latch (3) all the way to the right to release the service cover.
40 Chapter 5 Removal and replacement procedures for Customer Self-Repair parts
for initial safety procedures.
Spare part number
M23347-001
(Preparation for disassembly
ENWW