Multiple-Pin Horizontal Connector (Lvds Cable To Display Panel); Multiple-Pin Vertical Connector (Lvds Cable To System Board) - HP ZBook Fury 17 G7 Maintenance And Service Manual

Multiple-pin horizontal connector (LVDS cable to display panel)

Use these procedures to properly insert and remove a multiple-pin horizontal connector.
Insert procedure:
1. Slide connector evenly into receptacle on same horizontal plane as PCB connector.
2. Pull lock bar to insert and push both side connector horizontally to firmly lock.
3. Tape down lock bar over the panel to hold in position.
Reverse the previous procedure to remove the connector:
1. Remove tape.
2. Pull up bar (pull tape) and release the lock with the PCB connector.
3. Pull to the direction in parallel with PCB to withdraw the connector.

Multiple-pin vertical connector (LVDS cable to system board)

Use this procedure to properly insert and remove a multiple-pin vertical connector.
Remove the connector gasket before removing the connector.
●
If the connector has a plastic pull tab, pull the tab to disconnect. Otherwise, use flat tool under the
●
connector to remove evenly. Do not pull on the cable to remove.
Press evenly when reseating, reconnecting, or installing the connector.
●
For more information about cable management, see
ENWW
Cable management on page 180.
Additional information 183