HP ZBook Fury 17 G7 Maintenance And Service Manual page 195

Handle cables with care to avoid damage.
●
Apply only the tension required to seat or unseat cables during insertion or removal from the connector.
●
When possible, handle cables by the connector or pull-strap.
●
● Route cables in such a way that they cannot be caught or snagged by parts being removed or replaced.
Keep cables away from direct contact with major heat sources, such as the heat sink. (Some air flow guides
●
have a cable guide that lets you route cables safely around the heat sink.)
Do not jam cables on top of daughterboards or memory modules (DIMMs). Circuit cards and DIMMs are not
●
designed to take excessive pressure.
Keep cables clear of any movable or rotating parts (such as a fan) to prevent them from being cut or
●
crimped when the component is lowered into its normal position.
In all cases, avoid bending or twisting the cables. Do not bend any cable sharply. A sharp bend can break
●
the internal wires.
● Do not rely on components like the keyboard or service door to push cables down internally. Always
position the cables to lie properly by themselves or in the cable guides and chassis areas designed for
cable routing.
IMPORTANT:
damage the cable pins and result in a failed device.
ENWW
Always release connector latch before removing the cable. Otherwise, pulling the cable could
Additional information 181