HP ZBook Fury 17 G7 Maintenance And Service Manual page 179

Table 7-51 Issues, possible causes, and fixes
Items
Symptoms
Fan never stops running
●
Generates heat
●
Decreased computer performance
●
ENWW
Procedures
Possible causes
BIOS not up to date.
●
Thermal condition (fan, air flow)—fan might not be defective but must run constantly to
●
remove excess heat generated by electrical components.
● Inappropriate configuration.
Troubleshooting steps
General actions
1. Verify whether BIOS is set to Fan Always on while on AC Power F10 Setup. When booting
the computer, press f10 to open Setup, and then select Advanced > Built-In Device
Options Menu.
2. Update BIOS and drivers (4. Update BIOS and drivers on page
default. BIOS can implement new fan characteristics and updates for other components.
3. Perform a hard reset (8. Hard reset on page
recorded thermal values in memory.
Thermal-related issue
1. Verify that fan is spinning. Reseat fan cable before moving to next step.
a. Check fan and connection. Reseat fan cable.
b. Be sure that no obstructions or dust are in heat sink fan, heat sink fin, or vent.
c. Test fan using HP PC Hardware Diagnostics (UEFI) tool
and Tools on page 109). Be sure that the fan is not producing loud noise and that
fan blades spin correctly.
d. Test with a verified working fan.
e. Replace the fan.
2. Verify thermal solution
Use Thermal Monitor tool (available only to authorized service providers and technicians)
(HP Thermal Monitor on page
thermal sensors are within limits after thermal condition is serviced.
115). Performing a hard reset can reset
(6. HP Hardware Diagnostics
111) to run stress test (processor and GPU) and verify that
Common issues and possible solutions 165
107) and reset BIOS to