Status Lights, Blinking Light Codes, Troubleshooting Lights, And Post Error Messages; Status Lights; Blinking Light Codes - HP ZBook Fury 17 G7 Maintenance And Service Manual

7. Status lights, blinking light codes, troubleshooting lights, and POST error messages

Carefully observe any behavior that the computer may be exhibiting: status lights, blinking lights, and POST error
messages during boot. It is important to understand what these indicators mean.

Status lights

The following table describes basic lights on the computer.
Table 7-6 Power button functions and lights and their descriptions
Component
Power button
Front power light
Front AC adapter and battery light
Front hard drive light
Rear AC adapter light

Blinking light codes

During startup, the computer may not boot properly. If this occurs, blinking light codes can help identify the
cause.
The computer uses the following blinking lights to identify a hardware component that reports an error during
startup. For more information, see
112 Chapter 7 Troubleshooting guide
Description
When the computer is off, press the button to turn on the computer.
When the computer is on, press the button briefly to initiate Sleep (Windows) or Suspend
(Linux®).
When the computer is in the Sleep state, press the button briefly to exit Sleep (Windows) or
Suspend (Linux).
When the computer is in Hibernation, press the button briefly to exit Hibernation.
IMPORTANT: Pressing and holding down the power button results in the loss of unsaved
information.
If the computer stops responding and operating system shutdown procedures are ineffective,
press and hold the power button.
On: The computer is on.
Blinking: The computer is in the Sleep state.
Off: The computer is off.
White: The computer is connected to external power, and the battery is charged from 90% to
99%.
Amber: The computer is connected to external power, and the battery is charged from 0 to
90%.
Blinking amber: A battery that is the only available power source has reached a low battery
level. When the battery reaches a critical battery level, the battery light blinks rapidly. By
default, the critical battery level is defined in Power Options as 5%.
Off: The battery is fully charged.
Blinking white: The hard drive is being accessed.
Amber: HP 3D DriveGuard has temporarily parked the hard drive.
White: The computer is connected to external power.
Off: The computer is not connected to external power.
Blinking lights and boot error codes on page 169.
ENWW