HP ZBook Fury 17 G7 Maintenance And Service Manual page 110

Before removing the I/O board, follow these steps:
1. Prepare the computer for disassembly
2. Remove the service cover
1. Battery (see
2. Solid-state drives 3 and 4 (see
3. Solid-state drive carrier (see
4. Hard drive (see
5. Keyboard (see
6. Fan/heat sink assembly (see
7. System board (see
Remove the I/O board:
1. Remove the three Phillips M2.5 × 6.0 screws (1) that secure the I/O board to the computer.
2. Remove the Phillips M2.5 × 3.6 screw (2) that secures the I/O board to the computer.
96 Chapter 6 Removal and replacement procedures for authorized service provider parts
(Preparation for disassembly on page
(Service cover on page
Battery on page 41)
Solid-state drives 3 and 4 on page
Solid-state drives 3 and 4 on page
Hard drive on page 44)
Keyboard on page 54)
Fan/heat sink assembly on page
System board on page
40), and then remove the following components:
42)
42)
79)
89)
66).
ENWW