I/O Board - HP ZBook Fury 17 G7 Maintenance And Service Manual

Before removing the RTC battery, follow these steps:
1. Prepare the computer for disassembly
2. Remove the service cover
1. Battery (see
2. Solid-state drives 3 and 4 (see
3. Solid-state drive carrier (see
4. Hard drive (see
5. Keyboard (see
6. Fan/heat sink assembly (see
7. System board (see
Remove the RTC battery:
1. Turn the removed system board upside down with the front toward you.
2. Insert a case utility tool (1) or similar thin plastic tool into the slot on the RTC battery socket and remove
the RTC battery (2) from the socket.
Reverse this procedure to install the RTC battery.

I/O board

To remove the I/O board, use this procedure and illustration.
Table 6-13 I/O board description and part number
Description
NOTE: The I/O board includes an I/O board includes audio jack, 3 USB ports, and a RJ45 jack.
For use only on vPro computer models
For use only on non-vPro computer models
ENWW
(Preparation for disassembly on page
(Service cover on page
Battery on page 41)
Solid-state drives 3 and 4 on page
Solid-state drives 3 and 4 on page
Hard drive on page 44)
Keyboard on page 54)
Fan/heat sink assembly on page
System board on page
40), and then remove the following components:
42)
42)
79)
89)
Component replacement procedures
66).
Spare part number
M20126-001
M20127-001
95