Safety Equipment And Operating Elements; Opening And Security Sensors (Combined); Collision Detection; Security Sensors Side Panel - Record S20 Series User Manual

4.2

Safety equipment and operating elements

Pos.
1
2
4.2.1

Opening and security sensors (combined)

Each passage area is monitored with opening and security sensors. If an opening or security sensor
is activated during the closing process while in AUTOMATIC or ONEWAY TRAFFIC operating mode,
then the respective sliding door will re-open/reverse again.
4.2.2

Collision detection

If a door wing hits an obstacle during the closing process, then the door will stop immediately and re-
open.
Equally, the door wing will stop immediately if the door hits an obstacle during the opening process.
The opening process will start anew after 3 seconds at extra slow speed.
4.2.3

Security sensors side panel

The opening area of the door wing (inside) is monitored by security sensors. The function of the sen-
sors is tested before each opening. If there is detection during the opening process, the door will stop
immediately and closes again.
4.3

Components of the system

Pieces
1
2 / 4
1 / 2
1 / 2
1
1
BAL_S20_EN_1V0_REC_121-006454590
Components
Trigger and safety sensor / combinati-
on sensor (inside and outside)
Control unit BDE-D
Designation
Switches and buttons
Key switch
Opening and safety sensors
Combi sensors
Drive technology
Motor ATE
Control Type: System 20
Bistable locking system - Type: VRR 20 for floor hoist
Emergency release (shell handle)
Pos. Components
3 Key switch BDE-V (option)
4 Manual release
Mounting location
Indoor or outdoor
Upper guide - inside and outside
In drive technology
In drive technology
In drive technology
In drive technology
Description
18/ 33
4