Table of Contents
Advertisement
6.2.2.4
"2.4 Extended setup"
Use this menu to set the alarm limits and the direction of action of these limits. The following
table contains an overview of the menus and parameters:
2.4.1
2.4.2
2.4.3
"2.4.1 Setpoint"
Use this menu to adjust setpoint processing to the special requirements of the application.
The following table contains an overview of the menus and parameters:
2.4.1.1 Direction
2.4.1.2 Limiting setpoint rate
2.4.1.3 Setpoint rate up
2.4.1.4 Setpoint rate down
"2.4.1.1 Direction"
Factory setting:
Setting options:
Purpose:
Description:
"2.4.1.2 Limiting setpoint rate"
Factory setting:
Setting options:
SITRANS VP300 with or without HART
Operating Instructions, 03/2011, A5E01258666-03
Setpoint
Free characteristic curve
Controller parameters
Standard
Standard
Inverted
Change direction of setpoint.
Use this parameter to reverse the direction of action of the setpoint.
The change in direction of action is mainly used for single-acting
actuators with the safety position "Up".
Off
Off
On
Auto
6.2 Parameter description
2.4.1.5 Characteristic curve
2.4.1.6 Current 0%
2.4.1.7 Current 100%
Operate
83
Advertisement
Table of Contents
