1.4 Reset - Siemens SITRANS VP300 Operating Instructions Manual

Setting options:
Purpose:
"1.3.7 Adopt values"
Requirements:
Factory setting:
Purpose:
Description:
6.2.1.4

"1.4 Reset"

This menu provides the following options:
● Delete the initialization values
● Reset to factory settings
● Repeat stroke calibration
"1.4.1 Reset initialization"
Factory setting:
Purpose:
SITRANS VP300 with or without HART
Operating Instructions, 03/2011, A5E01258666-03
 < 3 s
 3 ... 20 s
 > 20 s
The defined travel time affects the control parameters of the
positioner.
Preceding settings for device replacementhave been made.
Cancel
To set the positioner to the initialized status.
Select "OK" to accept the changed values. The values set above
come into effect. The positioner can now be set to automatic mode.
If you select "Cancel", the values are not accepted but remain in the
parameters.
Cancel
Reset initialization parameter to "Not initialized". All other parameter
settings are retained.
Operate
6.2 Parameter description
69