6.1.5
Changing operating mode
Requirement
Positioner is initialized, and you are in the measurement view.
Figure 6-5
Procedure
1. Once the display shows the measurement view, press
2. The positioner changes operating mode.
See also
Operating modes (Page 26)
SITRANS VP300 with or without HART
Operating Instructions, 03/2011, A5E01258666-03
Example: Measurement view in automatic mode
– Manual mode
In manual mode, the positioner does not react to the setpoint input by the 4 to 20 mA
signal. The flashing hand symbol in the display and the "Manual mode" status
message indicates that you are in manual mode:
The button functions in manual mode are as follows:
Use
and
to move the actuator.
Use
to change to the navigation view and then further to the parameter view.
Use
to change from manual mode to automatic mode.
– Automatic mode:
The button functions in automatic mode are as follows:
Use
to change to the navigation view and then further to the parameter view.
Use
,
or
to change from automatic mode to manual mode.
6.1 Operation overview
.
Operate
61