Installing and mounting
High operating force with pneumatic actuators
Risk of injury when working on control valves due to the high operating force of the pneumatic
actuator.
● Please observe the corresponding safety instructions for the pneumatic actuator in use.
Please note the following before working on the control valve and when attaching the
positioner
Danger of injury.
● Prior to working on the control valve, you must move the control valve into a completely
● Make sure that the valve has reached the pressureless state.
● If you interrupt the pneumatic auxiliary power to the positioner, the pressureless position
● When mounting, observe the following sequence imperatively to avoid injuries or
3.1
Freezing of the exhaust air outlets
NOTICE
Freezing of the exhaust air outlets
The exhaust air outlets
● Do not install the positioner with the base plate
SIPART PS100
Operating Instructions, 10/2018, A5E45863537.-AA
WARNING
CAUTION
pressureless state. Proceed as follows:
– Depressurize the actuator chambers.
– Switch off the supply air PZ.
– Lock the valve in its position.
may only be reached after a certain waiting time.
mechanical damage to the positioner/mounting kit:
– Mount the positioner mechanically.
– Connect the electrical auxiliary power supply.
– Connect the pneumatic auxiliary power supply.
– Commission the positioner.
②
can ice up. The function of the device is impaired.
①
pointing up.
3
9