Setup [20] - Siemens SIPART Series Operating Instructions Manual

7.3

SETUP [20]

Setting the device parameters.
Factory-set parameter values are printed in bold in the table.
③ ①
ID Status line
21 DIGITAL IN
22 BEHAVIOR DI
23 POLARITY DI
24 DIGITAL OUT
25 BEHAVIOR DO
26 POLARITY DO
28 DIRECTION
*) 29 CLOSE TYPE
SIPART PS100
Operating Instructions, 10/2018, A5E45863537.-AA
②
Main line Meaning
MENU Menu for setting the digital inputs. Available with in‐
stalled option with digital input (DI) and digital output
(DQ).
NONE Digital input is not active.
HOLD Holds the current valve position.
BUTTN Enables the button lock. Operation no longer possible.
MSG Activates the digital output.
GO CL Moves to valve position when digital input is activated,
as set in parameter "CLOSE LIMIT" [30].
GO OL Moves to valve position, as set in parameter "OPEN
LIMIT" [32].
HIGH Normally Open: Normally open contact
LOW Normally Close: Normally closed contact
MENU Menu for setting the digital outputs. Available with in‐
stalled option "Digital Input/Digital Output (DI/DO)".
NONE Digital output is not active.
ERR Activates the digital output in case of control deviation
or device fault.
ERR M Activates the digital output in case of manual mode,
control deviation or device fault.
HIGH Normally Open: Normally open contact
LOW Normally Close: Normally closed contact
AUTO Operating direction defined automatically during initi‐
alization
INVRT Inverted operating direction
FAST Fast response in end positions
TIGHT Maximum actuating force in end positions
SLOW Precise response in end positions
LIMIT Precise response, controlled to the value of "CLOSE
TYPE" [30].
Note
To not travel to the end stop in the end position of the valve, assign the
values "SLOW" or "LIMIT" to the "CLOSE TYPE" parameter.
Parameter assignment and addressing
7.3 SETUP [20]
27