Installing and mounting
3.2 Mounting to linear actuator
①
②
Figure 3-1
3.2
Mounting to linear actuator
Requirements
Depending on the stroke height, you will need the following mounting kit:
● 3 to 35 mm mounting kit 6DR4004-8V
● 35 to 130 mm mounting kit 6DR4004-8V and additional 6DR4004-8L
Parts list 6DR4004-8L
Serial
Quanti‐
Name
no.
ty
①
1
Lever
Parts list 6DR4004-8V
The numbers in "serial no." column refer to the images in the description of the procedure.
Serial
Quanti‐
Name
no.
ty
①
1
NAMUR mounting bracket
IEC 60534
②
1
Pick-up bracket
③
2
Clamping piece
④
1
Carrier pin
⑤
1
Pulley
⑥
1
Lever
⑦
2
U–bolts
10
Base plate
Exhaust air outlets
Exhaust air outlets, base plate
Note
For the range of stroke from 10 to 130 mm
Note
Standardized connection point for mount with fin, column or plane surface
Guides the pulley with the carrier pin and rotates the lever arm.
Installs the pick-up bracket on the actuator spindle
Installation with pulley
Installation with carrier pin
For the range of stroke from 3 to 35 mm
Only for actuators with columns
⑤
⑥
on lever
④
⑥
on lever
Operating Instructions, 10/2018, A5E45863537.-AA
SIPART PS100