Use And Maintenance Instructions; General Warnings; Warnings For The User; Cleaning The Case - Immergas DIM 2 ZONE ERP Instructions And Warnings

2
USE AND MAINTENANCE
INSTRUCTIONS

2.1 GENERAL WARNINGS.

If the device must be deactivated temporarily,
act directly on the main switch to power off the
system and work safely
• Attention: using any components that use
electrical power requires the observation of
some fundamental rules:
- do not touch the device with wet or moist parts
of the body; do not touch when barefoot.
- if the device is wall-mounted: do not pull the
electric cables, do not leave the device exposed
to the elements (rain, sun, etc.);
- the device power cable must not be replaced by
the user;
- in the event of damage to the cable, switch the
device off and exclusively contact professionally
qualified staff for replacement;
- if the device is not going to be used for a certain
period, disconnect the main power switch.

2.2 WARNINGS FOR THE USER.

This device does not require any regulation or
control by the user; the opening of the device front
lid is therefore prohibited.
The only operation that the user must perform is
that of periodically checking the water pressure of
the system in the boiler. The boiler pressure gauge
should read a value of between 1 and 1.2 bar.
If the pressure is below 1 bar (with the circuit cool),
restore normal pressure via the filling valve located
in the boiler (see boiler instruction book).
N.B.: close the valve after the operation.
If pressure values reach around 3 bar, the boiler
safety valve may be activated.
In this case, remove water from a radiator air
vent valve until a pressure of 1 bar is achieved,
or ask for assistance from professionally qualified
personnel.
In the event of frequent pressure drops, contact
qualified staff for assistance to eliminate any
system leakage.
At the end of its service life, the appliance must
not be disposed of like normal household waste
nor abandoned in the environment, but must
be removed by a professionally authorised
company. Contact the manufacturer for disposal
instructions.

2.3 CLEANING THE CASE.

Use damp cloths and neutral detergent to clean
the manifold casing. Never use abrasive or pow-
der detergents.
14