Strongway 52523 Owner's Manual page 7

Assemble the crane loosely until the entire assembly is complete. Make certain that you have a large,
clean, and uncluttered area for assembly. As the crane is large and heavy, you may have to lay out
the different parts on their sides, and tighten and erect the entire assembly once complete.
Step 1) Attach two Plates (#20) from two sides to the one end of the Crossbeam (#19). Secure
with the four Bolts (#1), Washers (#2), Spring Washers (#3), and Nuts (#4). Repeat for the
other end.
Step 2) Attach each Inner Vertical Post Assembly to the Crossbeam (#19). Secure with the 8 Bolts
(#1), Washers (#2), Spring Washers (#3), and Nuts (#4)
Step 3) Attach the four Swivel Casters with Brake (#27) to the Base Assembly (#26). Apply grease
to the zerk in each Caster.
Step 4) Attach each Outer Vertical Post Assembly (#24) to each Base Assembly (#26), making
certain that the slot at two sides of the Outer Vertical Post Assembly are facing the
Casters' direction. From the top, insert two (2) Bolts (#14) through the base of the Outer
Vertical Post Assembly, and into the Base Assembly (#26). Slip on the Washer (#2) and
Spring Washer (#3) and secure by tightening the Nuts (#4).
Page 7 of 13