Fingerprint Reader Board - HP ENVY 17m Maintenance And Service Manual

Fingerprint reader board

NOTE: The fingerprint reader board spare part kit does not include the cable. The board cable is available
using spare part number L52657-001.
Table 5-11 Fingerprint reader board descriptions and part numbers
Description
Fingerprint reader board for use in models with a stamped finish
Before removing the fingerprint reader board, follow these steps:
1. Prepare the computer for disassembly
2. Remove the bottom cover (see
3. Remove the battery (see
4. Remove the hard drive (see
Remove the fingerprint reader board:
1. Remove the Phillips M2.0 × 2.0 screw (1) that secures the fingerprint reader board bracket to the
computer.
2. Slide the bracket toward the side of the computer, and then remove it (2).
3. Disconnect the cable from the ZIF connector on the fingerprint reader board (3).
4. Remove the fingerprint reader board from the computer (4).
Reverse this procedure to install the fingerprint reader board.
(Preparation for disassembly on page
Bottom cover and rubber feet on page
Battery on page 30).
Hard drive, drive rubber holder, and cable on page
Spare part number
L52651-001
26).
27).
35).
Component replacement procedures 45