HP ENVY 17m Maintenance And Service Manual page 44

3. If it is necessary to remove the rubber hard drive cover, pull the sides of the cover outward (1), and then
remove the cover from the hard drive (2).
4. If it is necessary to remove the connector from the hard drive, lift the tape from the connector (1),
disconnect the connector from the rear of the drive (2), and then pull the cable through the hole in the
foil (3).
5. If it is necessary to install foil onto the hard drive:
a. Insert the connector onto the rear of the drive (1).
b. Insert the connector cable through the slot in the foil (2).
c. Place the tape on top of the connector (3).
d. Making sure the slots in the foil match up with screw holes in hard drive (4), install the foil onto the
hard drive (5)
36 Chapter 5 Removal and replacement procedures for authorized service provider parts