Set Up Information / Batteries - Health O Meter 2595KL User Instructions

SET UP INFORMATION / BATTERIES

Set Up Information (Refer to Figures 4- 5)
Place 6 C-cell batteries in the battery holder (see "Replacing Batteries" below), or plug the
1.
AC adapter into the chair scale assembly and into the power source.
Press the ON/OFF button to turn the scale on. The display will show "START", then "0.0".
2.
3. When the self-test function is complete:

The digital display reads "0.0".

"LB" or "KG" is indicated on the right side of the display.
4. Place a weight not to exceed 600 lb (270 kg) on the scale. The digital display should blink
- - - - - -
" " until the weight calculation is complete.
- - - - - -
5. Press the LBS/KG button to select the weight mode, either in kilograms or pounds.
6. Press the REWEIGH button; the digital display will read the weight on the chair scale
assembly. Pressing the REWEIGH button will reweigh the weight that is still on the chair
scale assembly.
7. Remove the weight from the chair scale assembly, the digital display will continue to show
the weight of the item that was on the scale.
Press the ZERO button; the digital display will return to "0.0".
8.
Press the ON/OFF button to turn the chair scale assembly off. The display will show "OFF"
9.
and will then shut off.
Note: If the set up procedure failed, go to the troubleshooting instructions. If the problem is still
not corrected, refer to qualified service personnel.
Installing / Replacing Batteries
1. Loosen the two plastic knobs found underneath the display assembly until the battery
holder is released from the chair scale assembly and rests on the plastic knobs.
2. Carefully pull out the cable to provide access to the battery holder.
3. Raise the battery holder and simultaneously rotate it counterclockwise 1/4 turn. Carefully
remove the holder from the chair scale assembly.
4. Install/replace the batteries with 6 new C-cell batteries.
5. Place the battery holder onto the plastic knobs by rotating it 1/4 turn clockwise.
6. Hold the battery holder close to the chair scale assembly and tighten the two plastic knobs
to secure in place. Be careful not to damage the cable.
KG Lockout
The default weighing mode for this scale can be changed from LB/KG to KG only. To change to
KG, turn the scale on and wait for the display to show "0.0", then press and hold the LBS/KG
button for 20 seconds until the scale beeps 6 times. The scale is now locked in the KG mode
and the user cannot toggle between LB and KG. To disable the KG Lockout feature, press and
hold the LBS/KG button for another 20 seconds until the scale beeps 6 times, indicating that the
user can again toggle between pounds and kilograms.
P/N UM2595KL_REV20200128
9