Configuring Storedge Applications; Running A Battery Self-Test - SolarEdge StorEdge Interface SESTI-S4 Installation Manual

21 Configuring StorEdge Applications
To set up communication with the Energy Meter:
If you are setting up communication with the meter before the battery, first perform
Steps 1-3 on page 20. After that, proceed with the steps below.
1. In the RS485-1 screen, select Add Modbus Device è Meter.
2. Set the Energy Meter's CT Rating according to the CT specifications. If the CT rating
value returns to 0, check communication with the CT.
3. Select Meter 1 è Meter Function è Export+Import (E+I).

Configuring StorEdge Applications

This section describes the StorEdge applications and how to configure the system.
Maximize Self-consumption (MSC)
In this mode, the battery is automatically charged and discharged to meet consumption
needs.
The battery has two states:
OFF – the battery is in standby
ON – the battery is controlled for maximized self-consumption
Battery OFF periods can be configured to extend battery lifetime by minimizing the
number of shallow discharges (for example at nighttime or during the winter).
To set up maximize self-consumption:
1. Access SetApp and select Commissioning è Power Control.
2. Select Energy Manager è Energy Control è Maximum Self Consumption.

Running a Battery Self-test

Run a battery self-test to check the battery's charge and discharge functionality.
To run a battery self-test:
1. Make sure the battery's circuit breaker switch is ON.
2. Switch the inverter ON/OFF/P switch to ON.
3. In SetApp, select Commissioning è Maintenance è Diagnostics è Self-Test è
Battery Self-Test è Run Test.
4. Wait for all tests to complete and check the results in the summary table.
If any of the tests have failed, see the table below for possible solutions:
StorEdge Interface Installation Guide MAN-01-00621-1.1