Added Or Changed Electrical Component Summary; Air Flow - Ricoh Ri 100 Manual

1. Overview of the Differences
No.
4 Lift Board
5 Lift Tray HP Sensor

Added or Changed Electrical Component Summary

No.
Motors
MT Ink mist collecting fans
(left and right)
PCBs
PCB Relay Board

Air Flow

The filter's life is 2,000 prints and must be replaced by the user.
If an alert message appears on the operation panel, replace both the left and right filters at the same
time.
After replacing the filter, the user must reset the counter on the UP menu. (The machine can continue
printing even without resetting. Instruct the user to reset it.)
Path
1. Collecting the ink mist with the filter
2. Passing through the fan.
3. Lowering the airflow by the 2 straightening boards and discharging the air.
If there is some ink mist that could not be collected in Step 1, it is collected by the filter
between the straightening boards (to prevent staining the user's wall with ink).
24
Part Name
Component
A fan attached on the upper rear part of the machine, one
each on the left and right. Collects the ink mist inside the
machine by the filter and discharges the mist.
Mainly relays signals between the lift board and the CTL
board. Also responsible for relaying signals between the
sensors (cassette carriage HP sensor, height sensor, cassette
size detection sensor, etc.)
This also controls the ink mist collecting fans.
No. Part Name
9 Ink mist collecting fan (left)
10 Ink mist collecting fan (right)
Function