B.2.3
Connecting NCS to Analog Input Module (AIM)
Requirement
You need the Analog Input Module (AIM), article number 6DR4004-6F or -8F, for the electrical
connection of the accessory part "NCS sensor for non-contacting position measurement" to the
positioner. The positioner supplies auxiliary power to the NCS sensor via the option module.
Wiring diagram
②
③
④
⑤
⑥
Figure B-7
SIPART PS2 with 4 to 20 mA/HART
Operating Instructions, 11/2019, A5E00074631-AE
Positioner (open state)
Terminal Ref: Green
Terminal Pos: Black
Terminal GND: Brown
Terminal Vcc: Yellow
Analog Input Module (AIM)
Example of connecting the NCS to the Analog Input Module (AIM)
External position detection
B.2 Non-Contacting Sensor
⑦
Cable clamp
⑧
Screw F3x8
⑨
Cable gland
⑩
Four-pole NCS cable
⑪
Non Contacting Sensor (NCS)
⑫
Cable shielding lug
281