Siemens SIPART PS2 Series Operating Instructions Manual page 205

5. Loosen the two fixing screws
6. Remove the basic electronics
7. Remove the fixing screws
Four screws for the single-acting pneumatic block. Five screws for the double-acting
pneumatic block.
8. Remove the pneumatic block
Make sure that the cord seal
9. Blow the existing dirt from the surface on which the pneumatic block was placed.
10.Remove the pressure sensor module
module.
Installation
1. Insert the new cord seal
2. Press the cord seal
3. Place the pressure sensor module
4. Place the pneumatic block
– Make sure that the cord seal
– Make sure that the pneumatic block engages with the centering elements
5. Screw the fixing screws
6. Tighten the fixing screws
7. Place the basic electronics
8. Screw in the two fixing screws
9. Tighten the fixing screws
10.Insert the ribbon cable
11.Place the plastic cap
12.Close the positioner as described in section "Closing the standard and and intrinsically safe
version (Page 53)".
13.For a positioner with order option -Z F01 "Fail in Place", adjust the parameter '51.PNEUM'
Pneumatics type (Page 160) from "Std" to "FIP".
14.Switch on the supply pressure PZ.
15.Initialize the positioner as described in section "Commissioning (Page 105)".
Result
The pressure sensor module is ready to use again.
SIPART PS2 with 4 to 20 mA/HART
Operating Instructions, 11/2019, A5E00074631-AE
④
④
into the groove on the pressure sensor module
on the baseplate.
②
②
⑥
⑦
⑨
.
10.6 Replace the pressure sensor module
⑥
of the basic electronics.
⑤
.
②
of the pneumatic block
①
.
④
of the pneumatic block is in the pneumatic block.
③
and the cord seal
into the new pressure sensor module
③
on the baseplate.
①
on the pressure sensor module
④
of the pneumatic block is in the pneumatic block.
into the pneumatic block
with a torque of 1.1 Nm.
⑤
onto the four holders of the adapter
⑥
of the basic electronics.
.
and all other ribbon cables onto the basic electronics
Service and maintenance
①
.
④
of the pressure sensor
③
.
③
on all sides.
③
.
④
①
.
⑧
.
(Page 202)
⑤
.
205