SolarEdge StorEdge Installation Manual page 72

71 Replacing an Inverter
Figure 25: Disconnecting the Connection Unit from the inverter
9. Remove the screws securing the inverter to the mounting brackets and lift the
inverter from the mounting bracket.
NOTE
If you remove the old inverter and do not immediately install a new one, use
insulation tape to isolate each of the AC and DC wires
10. Place the new inverter on the mounting brackets and secure it using the screws.
11. Insert the wires from the Connection Unit into the openings in the inverter and the
ferrite bead.
12. Fasten the two clips securing the Connection Unit to the inverter.
13. Reconnect the cables: Follow the instructions of Installing the Inverter on page 19.
StorEdge Single Phase Inverter with HD-Wave Technology MAN-01-00627-1.1
Figure 26: Mounting brackets