Table of Contents
Advertisement
Setup and Installation
Getting Started - Quick Install & Test
This guide provides important safety information which should be read
thoroughly before permanently installing the speaker.
1. Connect the 8190S SIP Classroom Speaker with Strobe to an IEEE 802.3at PoE+.
The blue light at the top will remain on until boot up is completed – about 30
seconds.
Use of PoE+ is highly recommended for full functionality.
2. After the blue LED turns off and you hear a tone, press the reset switch (RST) button
on the back of the unit to hear the IP address over the speaker. The IP address may
also be discovered by downloading the Algo Locator Tool to find Algo devices on
your network:
3. Mount the speaker per the instructions in the next section
4. Access the 8190S web page by entering the IP address into a browser (Chrome,
Firefox etc.) and login using the default password: algo
5. Enter the IP address or the name for the SIP server into the SIP Domain field under
the Basic Settings > SIP tab.
6. Enter the Ring and/or Page SIP extension and credentials. Leave the credentials
blank for either extension if there is no intended use to have both registered.
(Note: The speaker supports multiple Ring, Emergency Alert, and Page SIP
extensions. The Page extension auto-answers for voice announcements. The Ring
and Emergency Alert extensions will play a WAV file over the speaker without
answering.)
7. Make a test call from a telephone to the speaker for one or both extensions. The
Page SIP extension should auto-answer, play the default pre-announce WAV file
with light pattern, and open a speech path to make a voice announcement. The Ring
SIP extension will play the default WAV file with pre-configure light pattern.
Document 90-00105
03/09/2020
Page 9
www.algosolutions.com/locator
Algo Communication Products Ltd
4500 Beedie St Burnaby BC Canada V5J 5L2
www.algosolutions.com
8190S SIP Classroom Speaker with Strobe FW 3.1
support@algosolutions.com
(604) 454-3792
Advertisement
Table of Contents
