Table of Contents
Advertisement
Ambient Noise Compensation
The 8190S' can automatically adjusts loud ring and paging volume to compensate for
background ambient noise. If 'Ambient Noise Compensation' is enabled, the alert volume
will get louder or quieter by the same dB level as the ambient noise measured just prior to
the alert.
Configuration & Provisioning
Configuration can be done through a web interface control panel or by using the program
buttons on the back of the unit. Central provisioning may also be used to allow units to be
pre-configured for a specific server prior to deployment in the field. Configuration files are
automatically downloaded from a server (via TFTP, FTP, HTTP, HTTPS) using DHCP.
Reset Button
A recessed reset button (RST) on the back can be used to reset the 8190S at time of
power up. To return all the settings to the factory default for the 8190S, wait until the blue
LED flashes, then press and hold the reset button until the blue LED begins a double flash
pattern. Release the reset button and allow the unit to complete its boot process. Do not
press the reset button until the blue LED begins flashing.
A reset will set all configuration options to factory default including the password.
Once booting has completed, pressing the reset button will cause the speaker to
announce its IP address over the speaker.
Document 90-00105
03/09/2020
Page 8
Algo Communication Products Ltd
4500 Beedie St Burnaby BC Canada V5J 5L2
www.algosolutions.com
8190S SIP Classroom Speaker with Strobe FW 3.1
support@algosolutions.com
(604) 454-3792
Advertisement
Table of Contents
