Connector Board - HP Chromebook 11 G8 Education Edition Maintenance And Service Manual

Connector board

Table 5-6 Connector board spare part information
Description
Connector board (includes audio jack and USB port and rubber bumper)
Before removing the connector board, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet, and then
unplugging the AC adapter from the computer.
4. Remove the keyboard/top cover (see
5. Disconnect the battery cable from the system board (see
Remove the connector board:
1. Release the shielding (1) that covers the connector board cable ZIF connectors on the system board.
2. Release the ZIF connectors (2) to which the connector board cables are connected, and then disconnect
the connector board cables from the system board.
3. Release the shielding (3) that covers the power cable connector.
4. Disconnect the power cable (4) from the connector board.
5. Remove the two Phillips M2.0×4.2 screws (5) that secure the connector board to the bottom cover.
6. Remove the left-side I/O bracket (6).
The left-side I/O bracket is available using spare part number L89793-001.
36 Chapter 5 Removal and replacement procedures
Keyboard/top cover on page
Battery on page
Spare part number
L89792-001
23).
31).