Predelivery; Before Start-Up - BRP Evinrude E-Tec Series Installation Manual

PREDELIVERY

BEFORE START-UP

Gearcase Lubricant
With out board vertical, check t he gea rcase lub ri-
cant level:
Remove the lubricant level plug. Lubricant must
•
be even with the bottom of the threaded hole.
A clean tie strap can be used as a "dip stick" if
•
the lubricant level is not obvious.
Add HPF PRO gearcase lubricant as needed.
•
1
1. Gearcase lubricant level
Oil Level
Make sure oil tank contains an adequate supply of
the correct lubricant fo r the out board and that the
LOW OIL warning has bee n tested. Refer to Rec-
ommended Lubricants on p. 77.
When starting the outboard for the first time, refer
to OIL SUPPLY PRIMING on p. 79.
Trim and Tilt Fluid
Correct fluid level must be maintained to
ensure operation of the impact protection
built into the unit.
Make sure trim and tilt reservoir is full before run-
ning outboard:
Tilt the outboard and engage the tilt support.
•
Remove filler cap and check fluid level.
•
Three Ram System–Add Power Trim/Tilt Fluid
•
or GM Dexron II, as needed, to bring level to the
bottom of the fill plug threads.
000072
Three Ram System, 75 - 300 HP
1. Filler cap
PREDELIVERY
BEFORE START-UP
A
CAUTION
5
1
004277
83