Break-In Oiling - BRP Evinrude E-Tec Series Installation Manual

FUEL AND OIL PRIMING
OIL REQUIREMENTS
Powerhead oil programming la bels a re pr ovided
to ident ify EMM oil prog ramming. Inst all the cor-
rect label to alert user to specific oil requirements.
1
1. Evinrude/Johnson XD30 outboard lubricant (TC-W3)
YELLOW label
2. Evinrude/Johnson XD100 outboard lubricant (Premium)
BLUE label (Installed)
An XD100 Outb oard Oil De cal, P/N 352369, is
available to la bel b oats eq uipped with o utboards
that have been progra mmed for the redu ced oil
injection ratio.
NOTICE
This outboard has been programmed for
the use of Evinrude
outboard oil ONLY.
Failure to use Evinrude
XD100™ outboard oil may harm engine
performance and shorten engine life.
XD100 Outboard Oil Decal
78
004964
® ®
/Johnson XD100™
® ®
/Johnson
355627
355627
Install decals in a hig hly visible location, su ch as
one of the following:
Dashboard/deck of boat, next to key switch
•
Deck of boat, next to the remote oil fill
•
Deck of boat, next to oil tank assembly
•
2
Oil tank cover
•
Cover of oil tank compartment
•
Attach to oil tank or oil fill cap.
•
IMPORTANT:
boat decals match EMM programming.

Break-In Oiling

IMPORTANT:
on Evinrude E-TEC models.
The Engine Management Module (EMM) will auto-
matically supply extra oil to the engine as follows:
90° V6: First two hours above 2000 RPM
•
60° V4 & V6: First five hours above 2000 RPM
•
40 – 90 HP: First two hours above 2000 RPM
•
15 – 30 HP: First two hours above 2000 RPM
•
Follow these steps for outboard set-up:
Use Evinrude Diagnostics sof tware to m ake
•
sure the break-in program has been started.
The oil t ank sh ould be filled a nd th e oil leve l
•
marked for reference.
NOTICE
The operator must monitor the oil
tank level to confirm oil consumption. This
may require several hours of operation above
idle.
Make sure the engine label an d
DO NOT add oil in the fuel tank