BRP Evinrude E-Tec Series Installation Manual page 69

SystemCheck Harness
Connections
Place th e wirin g harne ss through notch in lower
motor cover a nd ro ute t o the recess in th e fly-
wheel cover. Secure the cable with a tie strap as
shown:
1
1. Recess
2. Tie strap
Before installing electrical connectors, check t hat
the seal is in place. Cl ean off any dirt from con-
nectors. Apply a light coat of Electrical Grease to
the seal only. DO NOT fill connectors with Electri-
cal Grease.
1. Seal
EVINRUDE E-TEC MODELS 40–90 HP
Arrange connectors in flywheel cover.
2
Install electrical cover and secure with screws.
002011
NOTICE
BE SURE all harnesses and wires
are not pinched, cannot contact flywheel, and
do not interfere with moving throttle or shift
1 linkages.
42079A
OUTBOARD RIGGING
001999
002102
67
3