BRP Evinrude E-Tec Series Installation Manual page 68

OUTBOARD RIGGING
EVINRUDE E-TEC MODELS 40–90 HP
nion into the lower anchor pocket. Adjust the trun-
nion nut so the casing fits onto the shift lever pin.
1
1. Shift lever pin
2. Trunnion nut
If there are not enough threads on the shift cable
for the adjustme nt, or if the ge arcase does not
shift fully into FORWARD or REVERSE, refer to
the Service Manual for shift rod heig ht adjust-
ment.
With remote control lever in NEUTRAL, pull firmly
on throttle cable casing to remove slack.
With engine throt tle le ver aga inst stop, place the
cable trun nion in to th e u pper anchor p ocket a nd
adjust the trunnion nut so the casing fit s onto the
throttle lever pin.
1
1. Throttle lever pin
2. Trunnion nut
66
2
1. Throttle lever stop – 3 Cylinder models
002100
1. Throttle lever stop – 2 Cylinder models
IMPORTANT:
WARD and pull back slowly to NEUTRAL. Make
sure the engine throttle lever is against the stop. If
not, remove slack by adjusting cable trunnion.
After grommet has been inst alled in lower engine
2
cover, install the washers and retainer clips on the
throttle and sh ift lever pins. Refer to
Retainer Clip Installation on p. 51.
Install cable retainer and screw. Tighten screw to
a torque of 60 to 84 in. lbs. (7 to 9.5 N·m).
002101
Move control h andle t o F OR-
1
005111
1
005114
Cable
002103