BRP Evinrude E-Tec Series Installation Manual page 63

Connect outboard main wire harness to boat wire
harness. Secure connectors in brackets.
1. Harness connections
Route oil t ank sending unit harne ss around the
front to the po rt side. Se cure all cables with t ie
straps.
1. Low oil sender connection
2. Tie straps
Secure all cables with tie-straps.
1. Anchor points
EVINRUDE E-TEC 60° V MODELS 115–200 HP
NOTICE
BE SURE all harnesses and wires
are not pinched, cannot contact flywheel, and
do not interfere with moving throttle or shift
linkages.
Replace flywheel/harness connector cover.
I-Command Network Connections
1 If the outboard will b e used with I-Command, or
other NMEA 2000 compliant CANbus instruments,
use the following connecti ons to sup ply informa-
tion to the network:
If using an Evinrude ICON control syst em, the I-
004951
Command Engine Interface Cable, Power Supply
Kit, and Ig nition and Trim Harn ess a re n ot
required. Conne ct the
directly to the ICON g ateway modu le. Refer to
Evinrude ICON / I-Command Harness Connec-
tions on p. 14.
If using a mechanical control system, con nect the
I-Command En gine Interface Cable to the EMM
1
CANbus connector.
2
004952
1. EMM CANbus connector
1
005270
OUTBOARD RIGGING
I-Command network
1
005267
61
3