Evinrude E-Tec 60° Vmodels 115-200 Hp - BRP Evinrude E-Tec Series Installation Manual

OUTBOARD RIGGING
EVINRUDE E-TEC 60° V MODELS 115–200 HP
EVINRUDE E-TEC 60° V
MODELS 115–200 HP
Cable, Hose, and Wire Routing
A
CAUTION
To prevent accidental starting while servic-
ing, disconnect the battery cables at the
battery. Twist and remove all spark plug
leads.
Refer to Control Cable Identification on p. 51.
Remove two screws and bracket that fasten the
grommet to lower motor cover.
1. Grommet retaining bracket
Route all hoses, control
through a prot ective sleeve or cond uit in to the
boat and through the grommet.
The fuel h ose may b e routed through the protec-
tive sleeve or throu gh an alternate
lower motor cover grommet.
To route the fuel hose outside the sleeve, trim the
material covering the altern ate fuel hose slot in
the grommet.
1. Alternate fuel hose location
58
1
003964
cables, and wiring
hole in the
1
003970
Refer to the following d iagram to ensure prop er
positioning of rigging components in grommet.
10
9
5
1. Fuel supply hose
2. Fuel supply hose--alternate location
3. Oil supply hose
4. Oil tank sending unit harness
5. Battery cables
6. Main wire harness (MWS)
7. Shift cable
8. Throttle cable
9. Accessory charge wires
10. I-Command harness
11. Water pressure hose
12. Speedometer hose
1. Alternate fuel hose location
The main wiring harness, battery cables, oil tank
sending unit h arness, and any ICON or I-Com-
mand network cables should be rout ed along the
11
6
12
8
4
7
3
1
2
000095c
1
004946