BRP Evinrude E-Tec Series Installation Manual page 37

Before drilling any mounting holes:
Make sure the hole locations provide enou gh
•
clearance for mounting bolts and washers.
Check the inside area of the transom for
•
obstructions.
Check transom height(s) at centerlines.
•
Drill fou r ½ in. (1 3 mm) mou nting hole s in the
appropriate locations.
Be sure to drill the required holes
IMPORTANT:
perpendicular to transom surface.
40 HP, M T
ANUAL ILT MODELS
25–30 HP, M T
ANUAL ILT
15 HP, P T M
OWER ILT ODELS
Center the ou tboard on the tra nsom (or mounting
bracket) and tighten clamp screws by hand.
Use each stern b racket's mounting h oles as a
guide to drill holes through the transom.
40 HP models require four 5/16 in. (8 mm) holes
•
25–30 HP mo dels require two 5/ 16 in . (8 mm)
•
holes
15 HP m odels require f our 5/16 i n. (8 mm )
•
holes.
M
ODELS
OUTBOARD INSTALLATION
TRANSOM MEASURING AND DRILLING
1
40 HP Models
1
25 – 30 HP Models
1
15 HP Models
2
1
002215
1
007998
1
007999
35