Control Installation - BRP Evinrude E-Tec Series Installation Manual

Control Installation

Plan the inst allation of re mote co ntrols carefully,
following all instructions provided with the control.
Select an appropriate location based on the boat
configuration.
1
1. Side console
2. Center console
The mounting location must be a
IMPORTANT:
flat surface and must be strong enough to provide
rigid support. S trengthen moun ting surface a s
necessary.
Place remote cont rol at proposed locatio n and
check clearan ce a round remote con trol leve r at
full throttle in FORWARD and then at full throttle in
REVERSE. There must be at least 2.5 in. (64 mm)
of clearance between the handle and any part of
the boat throughout the control lever travel.
2
Typical control clearances
Use an app ropriate drill template to cut mo unting
holes. T emplates are includ ed with the control
instructions.
005471
1. Template
Install control with hardware provided.
IMPORTANT:
bly is secure and does not move during operation.
REMOTE CONTROLS
FWD
85.5°
2.5 in (64 mm)
Make sure remote control assem-
BOAT RIGGING
NEUTRAL
15.0°
15.0°
REV
40.5°
007920
1
007922
9
1