Table of Contents
Advertisement
Do not use to transport or lift people or animals.
Operate on a hard, level surface.
Do not operate frame if the beam is not level.
Keep persons and property clear from under the load.
Do not leave loads suspended when the hoist is unattended.
Inspect the frame for damaged parts and loose bolts before each use.
Do not use frame if there are damaged parts. Replace parts before continuing use.
Do not adjust height or disassemble frame while loaded.
Not for use by or around children.
Note: See the Parts List (beginning on page 11) for part numbers.
1. Attach the upper front bracket (#5) and the upper back bracket (#6) to the desired location on the
post. Secure using M12x60 hex bolts (#14),
and M12 nuts (#12).
2.
Position the lower front bracket (#3) and the lower back brackets (#4) below the upper brackets
using M12x70 hex bolts (#13), Ø12 flat washers (#10), Ø12 spring washers (#11), and M12 nuts
(#12).
Assembly Instructions
Ø12 flat washers (#10), Ø12 spring washers (#11),
Page 6 of 14
Advertisement
Table of Contents
