Required Equipment For Calibration - Trans-Cal SSD120 M Series Installation And Calibration Manual

4.2 Required Equipment for Calibration:

(See Calibration Block Diagram 881669.)
1. SSD120-(XX)M installed within a flight altimeter.
2. +12 to 28VDC power supply.
3. IBM compatible computer with an available serial port.
Software requirement: Windows 98® using Hyper Terminal Ver. 5.0
by Hilgraeve.
(Available as a free download at http://www.hilgraeve.com)(Software
Note: The
Hyper Terminal program which is shipped with Windows 98® will
not function
correctly. You must download version 5.0 or better to use this
calibration program.)
4. Digitizer/PC interface cable. (See wiring harness diagram or order
881668 from
Trans-Cal Industries.)
5. Vacuum/pressure source and control capable of exercising the
digitizer/altimeter, pressure standard over the digitizer's operating
range. (Optional: ATS-200 or equal device which will allow the
display of the parallel 100 foot altitude data.)
13