3.
Instructions for maintenance and service
3.1.
Preparations
In order to work efficiently, the special tools and aids listed below are necessary:
record Flash-Programmer FPC with up-to-date software
•
Installation and commissioning instructions record system 20
•
•
Spare parts selection record system 20
3.2.
Schedule of periodical maintenance
Cleaning
Cleaning operator parts like tracks, wheels, locking device, etc.
•
Mechanical control
Control running gear: the stabilizer-wheels must easily be rolled by hand, with system 20
•
they may not (when door leaves are suspended) roll along when sliding the carriages. The
carbon fibre brushes must touch the track.
Control locking and MPV-locking devices (if applicable): control requires to be unplugged.
•
Slide door leaves by hand in closed position. Actuate locking device manually. The locking
device must be able to be easily actuated. Door leaves should show an approx. 1 mm play
in the locked position. Check MPV-locking elements in door leaf.
Control gear belt: check tension of gear belt, and if necessary retighten by shifting the
•
guide pulley support. Check correct positioning of operator wheel to ATE motor unit.
Screw connections: check that all screws are well tightened. Pay special attention to ele-
•
ments particularly under strain like e.g. corner brackets on door leaves.
Electrical connections: control correct connection of cables and plugs.
•
Profiles: control fixing and condition of aluminium, rubber and brush profiles, as well as
•
door leaf guides and, if need be, replace them.
Control attachment of casing and check for perfect positioning.
•
Clean control unit and safety elements and check for correct mechanical fitting.
•
Controlling functions and safety
Switch on mains voltage and plug in battery (if applicable).
•
Control silent running of door in automatic operating mode.
•
Check all functions of control unit.
•
Control actuating and safety devices and keep record.
•
record sliding door system 20
Instructions for maintenance and service
WARNING
Mechanical works on record system 20 may only be performed when the installa-
tion is disconnected from the mains and the battery (if existing) is disconnected.
Article no. 102-020.110.805
3
page 5