Error Codes - SolarEdge SE3500 Installation Manual

Error Codes

The error code numbers may differ depending on the type of inverter (single or three phase) as described in the table
below.
The error messages include an error number and a description in the following format:
C oded XXX error
XXXXXXXXXXXXXXXXXXXXX XXXXXXXXXXXXXXXXXXX
An error message is displayed for 30 seconds after which the inverter waits the necessary time to reconnect and
restart. Meanwhile, the LCD displays the reactivation message and the time remaining reconnection.
WARNING !
All warnings and cautions in this manual must be observed when troubleshooting errors.
Error AC # Error
# single
phase
1-4
N / A
4, 5, 8, 45, 48, 50-53,
12, 18-23, 94, 108-
111,113
39, 42, 45
112
N / A
9, 13
N / A
54
LCD Message
wind down. #
software error
Wrong AC connection The connections
AC overvoltage
Description
One of the fans is not working
Internal software error
lines of the inverter are incorrect,
for example: Line 1 AC network is
connected to line 2 of the inverter,
and there is no 120 and there is no 120 and there is no 120 between L1 between L1 between L1
o o o
and L2 and L3 to L2 on the inverter
side.
The internal hardware that
measures AC current has
measured substantially high output
currents. This can occur because of
changes in AC voltage or a
switching load near the site.
SolarEdge Installation Guide - MAN-01-00060-2.6
Appendix A: Errors and Troubleshooting
help
Check Status Fan Status Check Status Fan Status
- Three-phase UPS on page 42 (a replacement kit is - Three-phase UPS on page 42 (a replacement kit is
available from SolarEdge).
If the error persists, contact SolarEdge
support.
Switching between connections L1 and L2 or L2 and
L3
If the fault persists:
•
Check the AC connection of the inverter.
•
Check with the network operator if a large
surge source or irregular load exists near the
site.
•
If the network does not pose any problems,
contact SolarEdge support.