Fcc Compliance Statement - Algo 8186 User Manual

Configuration:
Provisioning:
Supervision:
NAT:
Environmental:
Dimensions:
Horn & Enclosure:
Mounting:
Aim Adjustment:
Weight:
Compliance:

FCC Compliance Statement

This equipment has been tested and found to comply with the limits for a Class A digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference when the equipment is operated in a
commercial environment. This equipment generates, uses, and can radiate radio
frequency energy, and if it is not installed and used in accordance with the instruction
manual, it may cause harmful interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful interference, in which case the
user will be required to correct the interference at his own expense.
Document 90-00079B
03/24/2020
Page 62
Closed
Normally 4-20mA
Closed with
supervision
Nominal 12V source, current limited to 40mA
Typical supervision resistor value = 1k ohm
Web interface (HTTP or HTTPS) or autoprovisioning server.
TFTP, FTP, HTTP, HTTPS
SNMP
STUN, CRLF Keep Alive
-40 to +122 deg F (-40 to +50 deg C); Designed to meet
IP66 requirements. Suitable for outdoor and wet
environments when properly installed.
11" x 6.6" x 10.5" (28cm x 16.8cm x 26.7cm)
UV stabilized outdoor rated plastic with stainless steel
mounting hardware.
Wall, ceiling, or double gang electrical box.
Three axis
6 lb (2.7 Kg)
EN60950:2001, IEEE 802.3-2008, RFC3261, RoHS, CE,
FCC Class A, CISPR 22 Class A, CISPR 24, CSA/UL (USA
& Canada)
Algo Communication Products Ltd
4500 Beedie St Burnaby BC Canada V5J 5L2
www.algosolutions.com
8186 SIP Horn Speaker FW 1.7
>20mA <4mA
(604) 454-3792
support@algosolutions.com