Immergas HYDRO 3 Instructions And Warnings page 41

Hide thumbs Also See for HYDRO 3:
Table of Contents

Advertisement

Available languages

Available languages

5.3 THE FOLLOWING SYMPTOMS DO
NOT CONSTITUTE A PROBLEM
FOR THE FAN COIL.
Symptoms
The system does not work.
Changing to "FAN" mode during
cooling mode.
White fog is coming out of the unit.
Fan coil cooling noise.
Dust is coming out of the unit.
The unit can give off a bad smell.
The fan does not turn.
• The fan coil does not start immediately after the ON/OFF key is pressed on the remote control. If the
operation LED flashes, the system is in normal condition.
• To prevent the internal evaporator from freezing, the system automatically changes to "FAN" mode and
then returns to cooling mode after a few moments.
• If the room temperature drops to the set-point, the indoor unit changes to "FAN" mode. The same applies
to the heating mode.
• When, during cooling, the humidity level is particularly high. If the inside of the indoor unit is extremely
obstructed, distribution of the temperature in the room becomes irregular. In this case, the inside of the
indoor unit needs cleaning. Call your dealer for more information. This operation must be carried out by
qualified staff.
• When the system is in cooling mode or is stopping, a low and continuous "hiss" can be heard. This noise
can be heard when the drain pump (optional accessory) is running.
• When the system stops after a heating operation, a sharp sound can be heard. This noise is produced by
the expansion and contraction of plastic parts caused by a variation in the temperature.
• A continuous and low "hiss" might be heard when the fan coil is running. This is caused by the water flow.
• A low hiss might be heard when the unit is started or as soon as it has stopped: this is caused by a variation
in the water flow or it stopping.
• When the unit is used for the first time after a long time. This occurs because there is dust inside the unit.
• The unit absorbs the smells of the rooms, furniture, cigarettes, etc. and re-emits them.
• During operation. The fan speed is controlled so as to optimise system operation.
41
Status

Advertisement

Table of Contents
loading

This manual is also suitable for:

Hydro 4

Table of Contents